HEIDENHAIN TNC 306 Technical Manual - Manual (Page 189)

3/97
TNC 406/TNC 306 6 Display and operation 4 4-89
6.9 Code-numbers
The MOD functions can be used to enter code-numbers for the control. These code numbers can be
used to activate certain control functions.
Code-number Function
95 148 Select machine parameter list
807 667 Select PLC mode
105 296 Correction tables for the non-linear axis-error compensation
86 357 Remove program protection
75 368 Automatic offset adjustment
123 Select the user-available list of machine parameters
531 210 Erase markers M1000 to M2000 and Byte 0 to Byte 127
The value of the code-number which is entered is stored in Doubleword D276, except the code
numbers above The machine manufacturer can evaluate this code with the aid of the PLC and define
his own functions for code numbers or disable the preset code numbers.
D276 Value of the code-number most recently entered by MOD
6.10 Programming station
Machine parameters can be used to set the control so that it can be utilized as a programming
station, without the machine. In this setting only the operating modes "Programming and editing"
and "Test run" function. It is possible to select whether the PLC should be active or not in the
"programming station" setting.
MP7210 Programming station
Entry: 0, 1, 2
0 = Control and programming
1 = Programming station, "PLC active"
2 = Programming station, "PLC inactive"
6.11 Decimal sign
The decimal sign can be selected by machine parameter.
MP7280 Decimal sign
Entry: 0 or 1
0 = Decimal comma
1 = Decimal point