HEIDENHAIN TNC 306 Technical Manual - Manual (Page 259)

3/2000
TNC 416/TNC 406/TNC 306 List of machine parameters 5-11
3.2 Positioning
Machine
parameter Function and input Change
via Reaction Page
MP1010.0–4 Rapid traverse
Entry range, linear axis:
80 to 30 000 [mm/min]
Entry range, rotary axis:
80 to 30 000 [°/min]
4–42
MP1020.0–4 Manual feed
Entry range, linear axis:
80 to 30 000 [mm/min]
Entry range, rotary axis:
80 to 30 000 [°/min]
4–43
MP1030.0–4 Positioning window
Entry range, linear axis:
0.001 to 2.000 [mm]
Entry range, rotary axis:
0.001 to 2.000 [°]
4–48
MP1040 Polarity of the nominal value voltage for positive
traverse direction
Entry range: 0 to 15 (TNC 306)
% xxxxx (TNC 416/406)
Bit 0 X axis +0 = Positive
+1 = Negative
Bit 1 Y axis +0 = Positive
+2 = Negative
Bit 2 Z axis +0 = Positive
+4 = Negative
Bit 3 4 th axis +0 = Positive
+8 = Negative
Bit 4 * 5 th axis +0 = Positive
+16 = Negative
4–7
MP1050.0–4 Analog voltage for rapid traverse
Entry range: +4.5 to +9 [V]
4–42
MP1060.0–4 Acceleration
Entry range: 0.001 to 9.0 [m/s 2 ]
4–41
MP1070 Radial acceleration
Entry range: 0.001 to 3.0 [m/s
2 ]
4–45
MP1090 Default feed rate during positioning
Entry range: 0 to 30 000 [mm/min] 123 4–60
MP1092
MP1093
MP1094
MP1095
MP1096
MP1097
Circular feed rates in the disk cycle (marker M2640)
Entry range: 0 to 30 000 [mm/min]
Modes 0 and 4 (erosion, M2640=0)
Modes 0 and 4 (spark–out, M2640=1)
Modes 1 and 5 (erosion, M2640=0)
Modes 1 and 5 (spark–out, M2640=1)
Modes 2/3 and 6/7 (erosion, M2640=0)
Modes 2/3 and 6/7 (spark–out, M2640=1) 123 4–88