HEIDENHAIN TNC 306 Technical Manual - Manual (Page 104)

4-4
TNC 406/TNC 306 3/97
15 Commissioning and start-up procedure 4-138
15.1 Code numbers for commissioning 4-138
15.2 Preparation of the machine 4-138
15.3 Commissioning the control 4-142
15.3.1 Entry of the provisional and pre-defined machine parameters 4-142
15.3.2 Entry of the PLC-program 4-142
15.3.3 Testing the EMERGENCY STOP routine 4-142
15.3.4 Testing the direction of traverse 4-142
15.3.5 Setting the software limit switch ranges 4-144
15.3.6 Optimizing control with servo lag 4-144
15.3.7 Offset adjustment 4-147
15.3.8 Adjusting the monitoring functions 4-147