HEIDENHAIN TNC 306 Technical Manual - Manual (Page 133)

3/97
TNC 406/TNC 306 2 Reference marks 4-33
MP1320 Direction for traversing the reference marks
Entry range: 0 to 31
Bit 0 X axis: + 0 = positive
+ 1 = negative
Bit 1 Y axis: + 0 = positive
+ 2 = negative
Bit 2 Z axis: + 0 = positive
+ 4 = negative
Bit 3 Axis 4: + 0 = positive
+ 8 = negative
Bit 4 * Axis 5: + 0 = positive
+ 16 = negative
MP1330 Feed rate for traversing the reference marks
Entry range: 80 to 30 000 [mm/min]
MP1330.0 X axis
MP1330.1 Y axis
MP1330.2 Z axis
MP1330.3 Axis 4
MP1330.4 * Axis 5
MP1331 Feed rate for leaving the reference end position
(only for encoders with one reference mark MP1350=1)
Entry range: 80 to 500 [mm/min]
MP1331.0 X axis
MP1331.1 Y axis
MP1331.2 Z axis
MP1331.3 Axis 4
MP1331.4 * Axis 5
MP1340 Sequence for traversing reference marks
Entry: 0 = no evaluation of the reference mark
1 = X axis
2 = Y axis
3 = Z axis
4 = Axis 4
5 = Axis 5
MP1340.0 1st axis
MP1340.1 2nd axis
MP1340.2 3rd axis
MP1340.3 4th axis
MP1340.4 * 5th axis
* only TNC 406