HEIDENHAIN TNC 306 Technical Manual - Manual (Page 116)

4-16
TNC 406/TNC 306 1 Machine axes 3/97
1.5 Lubrication pulse
The PLC can control the lubrication of the guideway according to the distance traveled on each axis.
Machine parameter MP4060.X defines the distance for each axis after which lubrication is to be
performed. Entry is in units of 65 536 µm.
Example:
Desired traversing distance: 100 m
Value entered =
100 000 000 µm
65 536 µm
= 1526
If the stored path limit for an axis is exceeded, the NC sets a marker (M2012 to M2015) to 1.
After carrying out the lubrication the PLC is able reset the accumulated traverse distance (M2548 to
M2551).
MP4060 Path-dependent lubrication
Entry range: 0 to 65 535 (units of 65 536 µm)
MP4060.0 X axis
MP4060.1 Y axis
MP4060.2 Z axis
MP4060.3 Axis 4
MP4060.4 * Axis 5
Set Reset
M2012 Lubrication pulse X axis, since value of MP4060.0 NC NC
was exceeded
M2013 Lubrication pulse Y axis, since value of MP4060.1
was exceeded
M2014 Lubrication pulse Z axis, since value of MP4060.2
was exceeded
M2015 Lubrication pulse axis 4, since value of MP4060.3
was exceeded
M2016 * Lubrication pulse axis 5, since value of MP4060.4
was exceeded
* only TNC 406