HEIDENHAIN TNC 306 Technical Manual - Manual (Page 188)

4-88
TNC 406/TNC 306 6 Display and operation 4 3/97
MP1092
to
MP1097
Circular feed rates in the disk cycle
(if marker M2640 is set)
Entry range: 0 to 30 000 [mm/min]
MP1092 Modes: 0 and 4 (erosion, M2640=0)
MP1093 Modes: 0 and 4 (spark-out, M2640=1)
MP1094 Modes: 1 and 5 (erosion, M2640=0)
MP1095 Modes: 1 and 5 (spark-out, M2640=1)
MP1096 Modes: 2/3 and 6/7 (erosion, M2640=0)
MP1097 Modes: 2/3 and 6/7 (spark-out, M2640=1)
Set Reset
M2616 Free run during erosion or spark-out is completed PLC PLC
M2640 Selects the circular feed rate in the disk cycle PLC PLC
M2783 End of eroding path reached (WTG = 0) NC NC
M2787 Disk erosion in the last circle NC NC
M2620 Feed rate from MP2060 becomes active PLC PLC
M2790 Disk erosion completed (MOD 0 to 3) NC PLC
M2791 Disk erosion completed (MOD 4 to 7) NC PLC
W394 Actual angle while disk cycle NC NC
6.8 User-parameters
With the MOD-function up to 16 different machine parameters can be made accessible to the
machine operator as User-parameters.
The machine manufacturer determines in machine parameter MP7330.x which machine parameters
are to be defined as User-parameters.
The dialogs for the user-parameters are defined in the PLC dialogs.
MP7330 Determination of user parameters accessible via MOD function
Entry range: 0 to 9999.00 (No. of the desired machine parameter).
MP7330.0 User-parameter 0
MP7330.1 User-parameter 1
. .
. .
MP7330.14 User-parameter 14
MP7330.15 User-parameter 15