HEIDENHAIN TNC 306 Technical Manual User Manual
Page 157

3/97
TNC 406/TNC 306
4 Gap control
4-57
MP2030
Characteristic kink
Entry range: 0 to 100 (%)
MP2030.0
Input characteristic range 2.5 to 5V
(100% = 5V)
(0% = 2.5V)
MP2030.1
Input characteristic range 0 to 2.5V
(100% = 0V)
(0% = 2.5V)
MP2070
Feed rate at maximum gap voltage (5V)
and MP2020 = 1 and MP2030 = 1
Entry range: 1 to 100 (mm/min)
MP2080
Gap signal
Entry range: 0 to 2
0 = not inverted
1 = inverted
2 = analog input from spindle potentiometer
(for test purposes)
MP2131
Feed rate limited for switching to new eroding feed rate from MP2132
Entry range: 0 to 500 (mm/min)
MP2132
New eroding feed rate when value from MP2131 is exceeded
Entry range 0 to 500 (mm/min)
W392
Current value of the gap signal (NC -> PLC)
Range: 0 to 500 (1/100 V)
This manual is related to the following products: