HEIDENHAIN TNC 306 Technical Manual - Manual (Page 284)

3/2000
TNC416/TNC 406/TNC 306 List of Markers 6–7
Marker Function Set Reset Page
M2794 Changed values in eroding parameters Q96 to Q98
(without erosion tables: Q90 to Q99) NC PLC 4-67
M27951) Changed values in current table during program run
(M2796) NC PLC 4-67
M27961) Transfer changed values in current table to the PLC
(M2795) PLC NC 4-67
M2797 Manual generator setting –
M27981) Changed values in the status line and Q99 during erosion NC PLC 4-67
M27992) Strobe marker for activate the data transfer via RS-422/V.11 PLC NC 4-70
1) Active if MP2199 = 2 (see chapter "Machine integration," section "Eroding parameters")
2) only TNC 416/406