HEIDENHAIN TNC 306 Technical Manual - Manual (Page 274)

5-26
TNC 416/TNC 406/TNC 306 List of machine parameters 3/2000
Machine
parameter Function and input Change
via Reaction Page
MP7412 Behavior of CYCL CALL after a CYCL DEF 12:
PGM CALL xxxx block
Entry values: 0 or 1
0 = PGM xxxx is called with CYCL CALL like a
user cycle (PGM blocks do not appear)
1 = PGM xxxx is called with CYCL CALL or
M89/99 like a PGM CALL xxxx (PGM blocks
appear)
canceled in 286 18x-04/280 62x-10 123 –
MP7440 Output of M-functions
Entry range: 0 to 7
Programmed stop with M06
Bit 0
+ 0 = Programmed stop with M06
+ 1 = No programmed stop with M06
Output of M89, modal cycle call
Bit 1
+ 0 = No cycle call, normal output of
M89 at beginning of block
+ 2 = Modal cycle call at end of block
Axis standstill upon output of an M function
Bit 2
+ 0 = Axis standstill
+ 4 = No axis standstill
123 4-99
MP7460 Constant feed rate in corners
Entry range: 0 to 179.999 [°] 123 4-45
MP7470.0 Display mode for rotary axis defined with MP 410
Input: 0 or 1
0 =
0 to + 359.999 [°] (no software limit
switch)
1 = – 30 000.000 to + 30 000.000
(software limit switch active)
MP7470.1 Display mode for rotary axis defined with MP 411
Input: 0 or 1
0 =
0 to + 359.999 [°] (no software limit
switch)
1 = – 30 000.000 to + 30 000.000
(software limit switch active)
MP7480 Output of tool numbers with TOOL CALL block
Entry values: 0 to 2
0 = No output
1 = Output of tool number only when tool
number changes
2 = Output of tool number with every TOOL
CALL block
4-128