beautypg.com

2 feed rate display – HEIDENHAIN TNC 306 Technical Manual User Manual

Page 182

background image


4-82

TNC 406/TNC 306

6 Display and operation 4

3/97

6.3.2 Feed rate display

In the operating modes "Program run/single block" and "Program run/full sequence" the programmed
contouring feed rate is displayed when the feed potentiometer is in the 100% position. The feed
potentiometer can be used to vary this programmed feed rate from 0 to 150%.

In the manual operating modes the axis feed rate is displayed, after the axis-direction key is pressed.

MP7271

Feed rate display
Entry values: 0 or 1

0 = display
1 = no display

This manual is related to the following products: