HEIDENHAIN TNC 306 Technical Manual - Manual (Page 477)

3/97
TNC 406/TNC 306 Subject index 11-7
Power supply, VDU .......................................................................................3-20
Probing function ............................................................................................4-112
probing, manual .............................................................................................4-114
probing, successive .......................................................................................4-114
Program creation ...........................................................................................7-12
Program, ........................................................................................................4-90
Programming station .....................................................................................4-89
Programs, transferring from EPROM ............................................................7-8
Pull data from Data Stack (PL)......................................................................7-89
Pull logic accumulator from Data Stack (PLL)...............................................7-90
Pull word accumulator from Data Stack (PLW) ............................................7-90
Q
Q parameters.................................................................................................4-63; 9-4
Q parameters, global .....................................................................................9-4
Q parameters, local .......................................................................................9-4
R
RAM operation ..............................................................................................7-22
RAM test .......................................................................................................4-90
Range (Module 9010/9011/9012 ...................................................................7-110
Rapid traverse................................................................................................4-41; 4-42
Read in Word.................................................................................................7-110
Reference end-position .................................................................................4-28
Reference marks ...........................................................................................4-27; 4-33
Reference marks, direction for traversing .....................................................4-33
Reference marks, distance-coded.................................................................4-27
Reference marks, feed rate for leaving .........................................................4-33
Reference marks, passing over.....................................................................4-28
Reference marks, Sequence for traversing...................................................4-33
Reference point, shift of the..........................................................................4-77
Referencing to machine datum with M92 positioning blocks .......................4-77
REMAINDER .................................................................................................7-60; 7-74
REPLY............................................................................................................7-104
RESET............................................................................................................7-39
RESET NOT ...................................................................................................7-41
Restore position ............................................................................................4-90
Retraction of the electrode............................................................................4-59
Retraction speed ...........................................................................................4-59
Rotary axis, non-controlled ............................................................................4-54
Rotary encoder and ballscrew .......................................................................4-5
RPLY (REPLY)..............................................................................................7-105
RS 422/V.11...................................................................................................3-42; 4-68
RS-232-C interface.........................................................................................8-3; 8-11
S
Scaling factor .................................................................................................4-87
Servo accuracy ..............................................................................................4-43
Servo lag........................................................................................................4-41
Servo lag, optimizing .....................................................................................4-144
Servo positioning ...........................................................................................4-37
Servo sensitivity ............................................................................................4-66
SET ................................................................................................................7-38