HEIDENHAIN TNC 306 Technical Manual - Manual (Page 276)

5-28
TNC 416/TNC 406/TNC 306 List of machine parameters 3/2000
Machine
parameter Function and input Change
via Reaction Page
MP7645 Initializing parameters for handwheel
HR410
Input: 0 or 1
0 =
evaluation of the keys via NC
1 = evaluation of the keys via PLC
-
MP7650 Handwheel counting direction
Entry values: 0 or 1
0 = Positive counting direction
1 = Negative counting direction
4-117
MP7651 Short circuit monitoring during manual handwheel
traversing
Input:
0 = Short-circuit monitoring on
1 = Short-circuit monitoring off
as of 286 18x-04/280 62x-10 removed -
MP7655 Positioning with the handwheel
Entry values: 0 or 1
1 = Positioning with the handwheel is also
effective in the PROGRAMMING AND EDITING
mode of operation. -
MP7660 Threshold sensitivity for electronic handwheel
Entry value: 0 to 65 535 [increments] 4-117
MP7670.0
MP7670.0
MP7670.1
MP7670.2
Smallest interpolation factor for electronic
handwheel (HR 410/HR 130)
Interpolation factor for HR 410 at smallest speed
Interpolation factor for HR 410 at medium speed
Interpolation factor for HR 410 at greatest speed
Entry range: 0 to 10
4-118
MP7671
MP 7671.0
MP 7671.1
MP 7671.2
% Factor from MP1020.x for feed rate for HR410
% Factor for HR 410 at smallest feed rate
% Factor for HR 410 at medium feed rate
% Factor for HR 410 at greatest feed rate
Input range: 0 to 1000%
4-119
MP7680 Memory function for direction buttons
Entry values: 0 or 1
0 = Not stored
1 = stored
4-110