H3C Technologies H3C WX6000 Series Access Controllers - Manual (Page 85)

9-8
GVRP Configuration Example II
Network requirements
Configure GVRP for dynamic VLAN information registration and update among devices. Specify fixed
GVRP registration on AC and normal GVRP registration on Device.
Network diagram
Figure 9-3 Network diagram for GVRP configuration
Configuration procedure
1) Configure AC
# Enable GVRP globally.
system-view
[AC] gvrp
# Configure port GigabitEthernet 0/0/1 as a Trunk port, allowing all VLANs to pass.
[AC] interface GigabitEthernet 0/0/1
[AC-GigabitEthernet0/0/1] port link-type trunk
[AC-GigabitEthernet0/0/1] port trunk permit vlan all
# Enable GVRP on GigabitEthernet 0/0/1.
[AC-GigabitEthernet0/0/1] gvrp
# Set the GVRP registration type to fixed on the port.
[AC-GigabitEthernet0/0/1] gvrp registration fixed
[AC-GigabitEthernet0/0/1] quit
# Create VLAN 2 (a static VLAN).
[AC] vlan 2
2) Configure Device
# Enable GVRP globally.
system-view
[Device] gvrp
# Configure port GigabitEthernet 0/0/1 as a Trunk port, allowing all VLANs to pass.
[Device] interface GigabitEthernet 0/0/1
[Device-GigabitEthernet0/0/1] port link-type trunk
[Device-GigabitEthernet0/0/1] port trunk permit vlan all
# Enable GVRP on GigabitEthernet 0/0/1.
[Device-GigabitEthernet0/0/1] gvrp
[Device-GigabitEthernet0/0/1] quit
# Create VLAN 3 (a static VLAN).
[Sysname] vlan 3
3) Verify the configuration
# Display dynamic VLAN information on AC.
[AC] display vlan dynamic
No dynamic vlans exist!
# Display dynamic VLAN information on Device.