H3C Technologies H3C WX6000 Series Access Controllers - Manual (Page 597)

63-18
After an NQA test group is scheduled, you cannot enter the test group view or test type view.
Displaying and Maintaining NQA
To do… Use the command…
Display NQA test operation information
display nqa { result | history } [ admin-name
operation-tag ]
Display NQA server status display nqa server status
NQA Configuration Examples
ICMP-echo Test Configuration Example
Network requirements
Use the NQA ICMP function to test whether the NQA client (AC can send packets to the specified
destination (Switch) and test the roundtrip time of packets.
Network diagram
Figure 63-3 Network diagram for the ICMP-echo test
Configuration procedure
# Create an ICMP-echo test group and configure related test parameters.
system-view
[AC] nqa entry admin test
[AC-nqa-admin-test] type icmp-echo
[AC-nqa-admin-test-icmp-echo] destination ip 10.2.2.2
# Configure optional parameters.
[AC-nqa-admin-test-icmp-echo] probe count 10
[AC-nqa-admin-test-icmp-echo] probe timeout 500
[AC-nqa-admin-test-icmp-echo] quit
# Enable the ICMP-echo test operation.
[AC] nqa schedule admin test start-time now lifetime forever
# Display results of an ICMP-echo test.
[AC] display nqa result admin test
NQA entry(admin admin, tag test) test results:
Destination IP address: 10.2.2.2
Send operation times: 10 Receive response times: 10
Min/Max/Average round trip time: 0/16/1