H3C Technologies H3C WX6000 Series Access Controllers - Manual (Page 259)

25-25
To do… Use the command… Remarks
Enter system view system-view —
Enter OSPF view
ospf [ process-id | router-id
router-id ] *
—
Configure the maximum number of
OSPF routes maximum-routes { external |
inter | intra } number
Optional
The default number is 12288.
Configuring the Maximum Number of Load-balanced Routes
If several routes with the same cost to the same destination are available, configuring them as
load-balanced routes can improve link utilization.
Follow these steps to configure the maximum number of load-balanced routes:
To do… Use the command… Remarks
Enter system view system-view —
Enter OSPF view
ospf [ process-id | router-id
router-id ] *
—
Configure the maximum number of
equivalent load-balanced routes maximum load-balancing
maximum
Optional
The default number is 4.
Configuring a Priority for OSPF
A router may run multiple routing protocols, and it sets a priority for each protocol. When a route found
by several routing protocols, the route found by the protocol with the highest priority will be selected.
Follow these steps to configure a priority for OSPF:
To do… Use the command… Remarks
Enter system view system-view —
Enter OSPF view
ospf [ process-id | router-id
router-id ] *
—
Configure a priority for
OSPF preference [ ase ] [ route-policy
route-policy-name ] value
Optional
The priority of OSPF internal routes
defaults to 10.
The priority of OSPF external routes
defaults to 150.
Configuring OSPF Route Redistribution
Follow these steps to configure OSPF route redistribution:
To do… Use the command… Remarks
Enter system view system-view —
Enter OSPF view
ospf [ process-id | router-id
router-id ] *
—