H3C Technologies H3C WX6000 Series Access Controllers - Manual (Page 594)

63-15
To do… Use the command… Remarks
Configure the test type as DLSw
and enter test type view
type dlsw Required
Configure the destination address
for a test operation
destination ip ip-address
Required
By default, no destination IP
address is configured for a test
operation.
Configure the source IP address of
a probe request in a test operation
source ip ip-address
Optional
By default, no source IP address is
specified.
The source IP address must be
that of an interface on the device
and the interface must be up.
Otherwise, the test will fail.
Configure common optional
parameters
Refer to Configuring Optional
Parameters Common to an NQA
Test Group Optional
Configuring the Collaboration Function
Collaboration is implemented by establishing collaboration entries to monitor the detection results of the
current test group. If the number of consecutive probe failures reaches the threshold, the configured
action is triggered.
Follow these steps to configure the collaboration function:
To do… Use the command… Remarks
Enter system view system-view —
Enter NQA test group view
nqa entry admin-name
operation-tag
—
Enter test type view of the test
group
type { dhcp | dlsw | ftp | http |
icmp-echo | snmp | tcp |
udp-echo }
The collaboration function is not
supported in UDP-jitter tests.
Create a Reaction entry
reaction item-num
checked-element probe-fail
threshold-type consecutive
occurrences [ action-type { none |
trigger-only } ]
Required
Not created by default.
Exit to system view quit —
Create a Track object and
associate it with the specified
Reaction entry of the NQA test
group
track entry-number nqa entry
admin-name
operation-tag
reaction item-num
Required
Not created by default.
You cannot modify the content of a reaction entry using the reaction command after the collaboration
object is created.