H3C Technologies H3C WX6000 Series Access Controllers - Manual (Page 587)

63-8
To do… Use the command… Remarks
Enter system view system-view —
Enter NQA test group view
nqa entry admin-name
operation-tag
—
Configure the test type as FTP and
enter test type view
type ftp Required
Configure the destination address
for a test operation
destination ip ip-address
Required
By default, no destination IP
address is configured for a test
operation.
The destination IP address for a
test operation is the IP address of
the FTP server.
Configure the source IP address of
a probe request
source ip ip-address
Required
By default, no source IP address is
specified.
The source IP address must be
that of an interface on the device
and the interface must be up.
Otherwise, the test will fail.
Configure the operation type operation { get | put }
Optional
By default, the operation type for
the FTP is get, that is, obtaining
files from the FTP server.
Configure a login username username name
Required
By default, no login username is
configured.
Configure a login password password password
Required
By default, no login password is
configured.
Specify a file to be transferred
between the FTP server and the
FTP client
filename file-name
Required
By default, no file is specified.
Configure common optional
parameters
Refer to Configuring Optional
Parameters Common to an NQA
Test Group Optional
Configuring the HTTP Test
The HTTP test is used to test the connection with a specified HTTP server and the time required to
obtain data from the HTTP server.
Configuration prerequisites
Before performing an HTTP test, you need to configure the HTTP server.
Configuring the HTTP test
Follow these steps to configure the HTTP test: