H3C Technologies H3C WX6000 Series Access Controllers - Manual (Page 44)

2-14
Figure 2-5 Network diagram for Telnet connection establishment
Step 4: Launch Telnet on your PC, input the IP address of the management Ethernet interface of the
access controller, as shown in the following figure.
Figure 2-6 Launch Telnet
Step 5: Enter the password when the Telnet window displays Login authentication and prompts for
login password. The CLI prompt (such as ) appears if the password provided is correct. If all VTY
user interfaces of the access controller are in use, you will fail to establish the connection and receive
the message that says “The number of users currently using the system configuration has reached the
maximum. Please wait until one of the users releases the system configuration.”. An access controller
can accommodate up to five Telnet connections at same time.
Step 6: After successfully Telnetting to an access controller, you can configure the access controller or
display the information about the access controller by executing corresponding commands. You can
also type ? at any time for help. Refer to Basic Configuration Commands.chapter in System Maintaining
and Debugging in H3C WX6103 Access Controller Switch Interface Board Command Reference.
z
A Telnet connection will be terminated if you remove or modify the IP address of the VLAN
interface in the Telnet session.
z
By default, commands of level 0 are available to Telnet users authenticated by password. Refer to
Basic Configuration chapter in System Maintaining and Debugging in H3C WX6103 Access
Controller Switch Interface Board Configuration Guide for information about command level.