H3C Technologies H3C WX6000 Series Access Controllers - Manual (Page 33)

2-3
z
The auto-execute command command may cause you unable to perform common configuration
in the user interface, so use it with caution.
z
Before executing the auto-execute command command and save your configuration, make sure
you can log in to the access controller in other modes and can cancel the configuration.
Telnet Configurations for Different Authentication Modes
Table 2-3 lists Telnet configurations for different authentication modes.
Table 2-3 Telnet configurations for different authentication modes
Authentication
mode
Telnet configuration Description
None
Perform common
configuration Perform common Telnet
configuration Optional
Refer to
Table 2-2 .
Configure the
password Configure the password
for local authentication
Required
Password
Perform common
configuration Perform common Telnet
configuration Optional
Refer to
Table 2-2 .
Specify to perform
local
authentication or
RADIUS
authentication AAA configuration
specifies whether to
perform local
authentication or RADIUS
authentication
Optional
Local authentication is performed by
default.
Refer to AAA-RADIUS-HWTACACS
Configuration for more.
Configure user
name and
password Configure user names and
passwords for
local/remote users
Required
z
The user name and password of a
local user are configured on the
access controller switch interface
board.
z
The user name and password of a
remote user are configured on the
RADIUS server. Refer to user
manual of RADIUS server for more.
Manage VTY
users Set service type for VTY
users
Required
Scheme
Perform common
configuration Perform common Telnet
configuration Optional
Refer to
Table 2-2 .
Telnet Configuration with Authentication Mode Being None
Configuration Procedure
To do… Use the command… Remarks
Redirect to the OAP module oap connect slot 0 —
Enter system view system-view —