H3C Technologies H3C WX6000 Series Access Controllers - Manual (Page 402)

39-3
Displaying and Maintaining BOOTP Client Configuration
To do… Use the command… Remarks
Display related information on a
BOOTP client display bootp client [ interface
interface-type interface-number ]
Available in any view
BOOTP Client Configuration Example
Network requirement
AC’s port belonging to VLAN 1 is connected to the LAN. VLAN-interface 1 obtains an IP address from
the DHCP server by using BOOTP.
Network diagram
See Figure 37-1 .
Configuration procedure
The following describes only the configuration on AC serving as a client.
# Configure VLAN-interface 1 to dynamically obtain an IP address from the DHCP server.
system-view
[AC] interface vlan-interface 1
[AC-Vlan-interface1] ip address bootp-alloc
To make the BOOTP client to obtain an IP address from the DHCP server, you need to perform
additional configurations on the DHCP server. Since the DHCP server configuration varies with devices,
it is not mentioned here.