H3C Technologies H3C WX6000 Series Access Controllers - Manual (Page 337)

29-19
Configuration procedure
1) Configure the IP address of each interface
Configure an IP address and subnet mask for each interface as per Figure 29-3 . The detailed
configuration steps are omitted.
2) Configure Router
# Enable IP multicast routing, enable PIM-DM on each interface, and enable IGMPv2 on
GigabitEthernet 0/0/1.
system-view
[Router] multicast routing-enable
[Router] interface GigabitEthernet 0/0/1
[Router-GigabitEthernet0/0/1] igmp enable
[Router-GigabitEthernet0/0/1] pim dm
[Router-GigabitEthernet0/0/1] quit
[Router] interface GigabitEthernet 0/0/2
[Router-GigabitEthernet0/0/2] pim dm
[Router-GigabitEthernet0/0/2] quit
3) Configure AC
# Enable IGMP Snooping globally.
system-view
[AC] igmp-snooping
[AC-igmp-snooping] quit
# Create VLAN 100, assign GigabitEthernet 0/0/1 through GigabitEthernet 0/0/4 to this VLAN, and
enable IGMP Snooping in the VLAN.
[AC] vlan 100
[AC-vlan100] port GigabitEthernet 0/0/1 to GigabitEthernet 0/0/4
[AC-vlan100] igmp-snooping enable
[AC-vlan100] quit
# Enable simulated host joining on GigabitEthernet 0/0/3 and GigabitEthernet 0/0/4 respectively.
[AC] interface GigabitEthernet 0/0/3
[AC-GigabitEthernet0/0/3] igmp-snooping host-join 224.1.1.1 vlan 100
[AC-GigabitEthernet0/0/3] quit
[AC] interface GigabitEthernet 0/0/4
[AC-GigabitEthernet0/0/4] igmp-snooping host-join 224.1.1.1 vlan 100
[AC-GigabitEthernet0/0/4] quit
4) Verify the configuration
# View the detailed information about IGMP Snooping multicast groups in VLAN 100 on AC.
[AC] display igmp-snooping group vlan 100 verbose
Total 1 IP Group(s).
Total 1 IP Source(s).
Total 1 MAC Group(s).
Port flags: D-Dynamic port, S-Static port, A-Aggregation port, C-Copy port
Subvlan flags: R-Real VLAN, C-Copy VLAN
Vlan(id):100.
Total 1 IP Group(s).
Total 1 IP Source(s).
Total 1 MAC Group(s).
Router port(s):total 1 port.