H3C Technologies H3C WX6000 Series Access Controllers - Manual (Page 590)

63-11
To do… Use the command… Remarks
Configure the time for waiting for a
response in a UDP-jitter test probe packet-timeout
packet-timeout
Optional
3000 milliseconds by default.
Configure the source IP address of
a probe request in a test operation
source ip ip-address
Optional
By default, no source IP address is
specified.
The source IP address must be
that of an interface on the device
and the interface must be up.
Otherwise, the test will fail.
Configure common optional
parameters
Refer to Configuring Optional
Parameters Common to an NQA
Test Group Optional
The number of probes made in a UDP-jitter test depends on the probe count command, while the
number of probe packets sent in each probe depends on the probe packet-number command.
Configuring the SNMP Test
The SNMP query test is used to test the time the NQA client takes to send an SNMP query packet to the
SNMP agent and then receive a response packet.
Configuration prerequisites
The SNMP agent function must be enabled on the device serving as an SNMP agent before the SNMP
test. For the configuration of SNMP agent, refer to SNMP in H3C WX6103 Access Controller Switch
Interface Board Configuration Guide .
Configuring the SNMP test
Follow these steps to configure the SNMP test:
To do… Use the command… Remarks
Enter system view system-view —
Enter NQA test group view
nqa entry admin-name
operation-tag
—
Configure the test type as SNMP
and enter test type view
type snmp Required
Configure the destination address
for a test operation
destination ip ip-address
Required
By default, no destination IP
address is configured for a test
operation.
Specify the source port number for
a probe request in a test operation
source port port-number
Optional
By default, no source port number
is specified.