H3C Technologies H3C WX6000 Series Access Controllers - Manual (Page 41)

2-11
Table 2-6 Determine the command level when users logging in to the access controller switch interface
board are authenticated in the scheme mode
Scenario
Authentication
mode
User type Command
Command level
The user privilege level level command is not
executed, and the service-type command does
not specify the available command level.
Level 0
The user privilege level level command is not
executed, and the service-type command
specifies the available command level. Determined by the
service-type
command
The user privilege level level command is
executed, and the service-type command does
not specify the available command level.
Level 0
VTY users that
are
AAA&RADIUS
authenticated or
locally
authenticated
The user privilege level level command is
executed, and the service-type command
specifies the available command level. Determined by the
service-type
command
The user privilege level level command is not
executed, and the service-type command does
not specify the available command level.
The user privilege level level command is not
executed, and the service-type command
specifies the available command level.
Level 0
The user privilege level level command is
executed, and the service-type command does
not specify the available command level.
VTY users that
are
authenticated in
the RSA mode
of SSH
The user privilege level level command is
executed, and the service-type command
specifies the available command level.
Determined by the
user privilege
level
level
command
The user privilege level level command is not
executed, and the service-type command does
not specify the available command level.
Level 0
The user privilege level level command is not
executed, and the service-type command
specifies the available command level. Determined by the
service-type
command
The user privilege level level command is
executed, and the service-type command does
not specify the available command level.
Level 0
Scheme
(authentication-
mode scheme
[ command-aut
horization ]
)
VTY users that
are
authenticated in
the password
mode of SSH
The user privilege level level command is
executed, and the service-type command
specifies the available command level. Determined by the
service-type
command
Refer to SSH in H3C WX6103 Access Controller Switch Interface Board Configuration Guide for
information about SSH.