H3C Technologies H3C WX6000 Series Access Controllers - Manual (Page 436)

45-2
z
The policy name is determined.
z
Apply the QoS policy in Ethernet port view/port group view.
Defining a Class
To define a class, you need to create a class and then define rules in the corresponding class view.
Configuration procedure
Follow these steps to define a class:
To do… Use the command… Remarks
Enter system view system-view —
Create a class and enter the
corresponding class view traffic classifier classifier-name
[ operator { and | or } ]
Required
By default, the and keyword is
specified. That is, the relation
between the rules in the class view
is logic AND. This operation leads
you to class view.
Define a rule used to match
packets
if-match match-criteria Required
match-criteria : Matching rules to be defined for a class. Table 45-1 describes the available forms of this
argument.
Table 45-1 The form of the match-criteria argument
Form Description
acl access-list-number
Specifies an ACL to match packets. The access-list-number
argument is in the range 2000 to 4999.
In a class configured with the operator and, the logical relationship
between rules defined in the referenced IPv4 ACL is or.
acl ipv6 access-list-number
Specifies an IPv6 ACL to match IPv6 packets. The
access-list-number
argument is in the range 2000 to 3999.
In a class configured with the operator and, the logical relationship
between rules defined in the referenced IPv6 ACL is or.
any Specifies to match all packets.
customer-dot1p 8021p-list
Specifies to match packets by 802.1p precedence of the customer
network. The 8021p-list argument is a list of CoS values. You can
provide up to eight space-separated CoS values for this argument.
CoS is in the range 0 to 7.
customer-vlan-id vlan-id-list
Specifies to match the packets of specified VLANs of user
networks. The vlan-id-list argument specifies a list of VLAN IDs, in
the form of vlan-id to vlan-id or multiple discontinuous VLAN IDs
(separated by space). You can specify up to eight VLAN IDs for this
argument at a time. VLAN ID is in the range 1 to 4094.
In a class configured with the operator and, the logical relationship
between the customer VLAN IDs specified for the
customer-vlan-id
keyword is or.
destination-mac mac-address
Specifies to match the packets with a specified destination MAC
address.
dscp dscp-list
Specifies to match packets by DSCP precedence. The dscp-list
argument is a list of DSCP values. You can provide up to eight
space-separated DSCP values for this argument. DSCP is in the
range of 0 to 63.