H3C Technologies H3C WX6000 Series Access Controllers - Manual (Page 62)

7-7
Configuring an Access-Port-Based VLAN
There are two ways to configure Access-port-based VLAN: one way is to configure in VLAN view, the
other way is to configure in Ethernet port view/port group view.
Follow these steps to configure the Access-port-based VLAN in VLAN view:
To do… Use the command… Remarks
Enter system view system-view —
Enter VLAN view vlan vlan-id
Required
If the specified VLAN does not exist, this
command be created first creates the VLAN
before entering its view.
Add an Access port to the
current VLAN
port interface-list
Required
By default, system will add all ports to VLAN 1.
Follow these steps to configure the Access-port-based VLAN in Ethernet port view/port group view:
To do… Use the command… Remarks
Enter system view system-view —
Enter Ethernet
port view interface interface-type
interface-number
Enter Ethernet
port view or
port group
view
Enter port group
view
port-group { manual
port-group-name |
aggregation agg-id }
Use either command
In Ethernet port view, the subsequent
configurations only apply to the current port; In
port group view, the subsequent
configurations apply to all ports in the port
group.
Configure the port link type as
Access
port link-type access
Optional
The link type of a port is Access by default.
Add the current Access port to a
specified VLAN port access vlan
vlan-id
Optional
By default, all Access ports belong to VLAN 1.
To add an Access port to a VLAN, make sure the VLAN already exists.
Configuring a Trunk-Port-Based VLAN
A Trunk port may belong to multiple VLANs, and you can only perform this configuration in Ethernet port
view or port group view.