H3C Technologies H3C WX6000 Series Access Controllers User Manual
Page 465

50-9
[AC-GigabitEthernet0/0/3] port link-type trunk
[AC-GigabitEthernet0/0/3] port trunk permit vlan 2
2) Configure Switch A (the intermediate device).
# Configure port GigabitEthernet 0/0/1 as a trunk port and configure the port to permit the packets of
VLAN 2.
[SwitchA] interface GigabitEthernet 0/0/1
[SwitchA-GigabitEthernet0/0/1] port link-type trunk
[SwitchA-GigabitEthernet0/0/1] port trunk permit vlan 2
[SwitchA-GigabitEthernet0/0/1] quit
# Configure port GigabitEthernet 0/0/2 as a trunk port and configure the port to permit the packets of
VLAN 2.
[SwitchA] interface GigabitEthernet 0/0/2
[SwitchA-GigabitEthernet0/0/2] port link-type trunk
[SwitchA-GigabitEthernet0/0/2] port trunk permit vlan 2
3) Configure Switch B (the destination device).
# Configure port GigabitEthernet 0/0/1 as a trunk port and configure the port to permit the packets of
VLAN 2.
[SwitchB] interface GigabitEthernet 0/0/1
[SwitchB-GigabitEthernet0/0/1] port link-type trunk
[SwitchB-GigabitEthernet0/0/1] port trunk permit vlan 2
[SwitchB-GigabitEthernet0/0/1] quit
# Create a remote destination port mirroring group.
[SwitchB] mirroring-group 1 remote-destination
# Create VLAN 2.
[SwitchB] vlan 2
[SwitchB-vlan2] quit
# Configure VLAN 2 as the remote port mirroring VLAN of the remote destination port mirroring group.
Add port GigabitEthernet 0/0/2 to the remote destination port mirroring group as the destination port.
[SwitchB] mirroring-group 1 remote-probe vlan 2
[SwitchB] mirroring-group 1 monitor-port GigabitEthernet 0/0/2
[SwitchB] interface GigabitEthernet 0/0/2
[SwitchB-GigabitEthernet0/0/2] port access vlan 2
After finishing the configuration, you can monitor all the packets sent by Department 1 and Department
2 on the Data monitoring device.