H3C Technologies H3C WX6000 Series Access Controllers - Manual (Page 463)

50-7
Network diagram
Figure 50-3 Network diagram for local port mirroring configuration
Configuration procedure
Configure AC.
# Create a local port mirroring group.
system-view
[AC] mirroring-group 1 local
# Add port GigabitEthernet 0/0/1 and GigabitEthernet 0/0/2 to the port mirroring group as source ports.
Add port GigabitEthernet 0/0/3 to the port mirroring group as the destination port.
[AC] mirroring-group 1 mirroring-port GigabitEthernet 0/0/1 GigabitEthernet 0/0/2 both
[AC] mirroring-group 1 monitor-port GigabitEthernet 0/0/3
# Display the configuration of all the port mirroring groups.
[AC] display mirroring-group all
mirroring-group 1:
type: local
status: active
mirroring port:
GigabitEthernet0/0/1 both
GigabitEthernet0/0/2 both
monitor port: GigabitEthernet0/0/3
After finishing the configuration, you can monitor all the packets received and sent by R&D department
and Marketing department on the Data monitoring device.
Remote Port Mirroring Configuration Example
Network requirements
The departments of a company connect to each other through Ethernet switches:
z
Department 1 is connected to GigabitEthernet 0/0/1 of AC.
z
Department 2 is connected to GigabitEthernet 0/0/2 of AC.
z
GigabitEthernet 0/0/3 of AC connects to GigabitEthernet 0/0/1 of Switch A.
z
GigabitEthernet 0/0/2 of Switch A connects to GigabitEthernet 0/0/1 of Switch B.
z
The data monitoring device is connected to GigabitEthernet 0/0/2 of Switch B.