H3C Technologies H3C WX6000 Series Access Controllers - Manual (Page 304)

27-12
To do… Use the command… Remarks
Enter system view system-view —
Reset DLDP state dldp reset Required
Resetting DLDP State in Port view/Port Group View
Follow these steps to reset DLDP state in port view/port group view:
To do… Use the command… Remarks
Enter system view system-view —
Enter
Ethernet
port view
interface interface-type
interface-number Enter
Ethernet
port
view/port
group view
Enter port
group view port-group { aggregation agg-id |
manual port-group-name }
Either is required.
The configuration performed in
Ethernet port view applies to the
current port only; the configuration
performed in port group view applies
to all the ports in the port group.
Reset DLDP state dldp reset Required
Displaying and Maintaining DLDP
To do… Use the command… Remarks
Display the DLDP
configuration of a port display dldp [ interface-type
interface-number ]
Available in any view
Display the statistics on DLDP
packets passing through a
port
display dldp statistics [ interface-type
interface-number ]
Available in any view
Clear the statistics on DLDP
packets passing through a
port
reset dldp statistics [ interface-type
interface-number ]
Available in user view
DLDP Configuration Example
DLDP Configuration Example
Network requirements
z
AC and Switch are connected through two fiber pairs, in which two fibers are cross-connected, as
shown in
Figure 27-4 .
z
It is desired that the unidirectional links can be disconnected on being detected; and the ports shut
down by DLDP can be restored after the fiber connections are corrected.