H3C Technologies H3C WX6000 Series Access Controllers - Manual (Page 186)

20-28
To do... Use the command... Remarks
Enable the MSTP feature on the
port(s)
stp enable
Optional
MSTP is disabled on ports by
default and automatically enabled
on all ports after it is enabled
globally on the device.
z
You must enable MSTP for the device before any other MSTP-related configuration can take
effect.
z
To control MSTP flexibly, you can use the stp disable or undo stp command to disable the MSTP
feature for certain ports so that they will not take part in spanning tree calculation and thus to save
the device’s CPU resources.
Configuration example
# Enable MSTP for the device and disable MSTP on port GigabitEthernet 0/0/1.
system-view
[Sysname] stp enable
[Sysname] interface GigabitEthernet 0/0/1
[Sysname-GigabitEthernet0/0/1] stp disable
Configuring Leaf Nodes
Configuring an MST Region
Refer to Configuring an MST Region in the section about root bridge configuration.
Configuring the Work Mode of MSTP
Refer to Configuring the Work Mode of MSTP Device in the section about root bridge configuration.
Configuring the Timeout Factor
Refer to Configuring Timers of MSTP in the section about root bridge configuration.
Configuring the Maximum Transmission Rate of Ports
Refer to Configuring the Maximum Transmission Rate of Ports in the section about root bridge
configuration.
Configuring Ports as Edge Ports
Refer to Configuring Ports as Edge Ports in the section about root bridge configuration.