H3C Technologies H3C WX6000 Series Access Controllers - Manual (Page 550)

59-8
To do… Use the command… Remarks
Configure the format of the time
stamp
info-center timestamp
{ debugging | log | trap } { boot |
date
| none }
Optional
By default, the time stamp format
for log, trap and debugging
information is date.
Enabling the display of system information on a monitor terminal
After setting to output system information to a monitor terminal, you need to enable the associated
display function in order to display the output information on the monitor terminal.
Follow these steps to enable the display of system information on a monitor terminal:
To do… Use the command… Remarks
Enable the monitoring of system
information on a monitor terminal
terminal monitor
Required
Enabled on the console disabled
on the monitoring terminal by
default.
Enable the display of debugging
information on a monitor terminal
terminal debugging
Required
Disabled by default
Enable the display of log
information on a monitor terminal
terminal logging
Optional
Enabled by default
Enable the display of trap
information on a monitor terminal
terminal trapping
Optional
Enabled by default
Setting to Output System Information to a Log Host
To do… Use the command… Remarks
Enter system view system-view —
Enable information center info-center enable
Optional
Enabled by default
Name the channel with a specified
channel number
info-center channel
channel-number name
channel-name
Optional
Refer to
Table 59-2 for default
channel names.
Specify a log host and configure
the parameters when system
information is output to the log host
info-center loghost host-ip
[ channel { channel-number |
channel
-name } | facility
local -number ] *
Required
By default, the system does not
output information to a log host. If
you specify to output system
information to a log host, the
system uses channel 2 (loghost) by
default.
Configure the source interface
through which log information can
be output to a log host
info-center loghost source
interface-type interface-number
Optional
No source interface is configured
by default, and the system selects
an interface as the source
interface.