H3C Technologies H3C WX6000 Series Access Controllers - Manual (Page 174)

20-16
Task Remarks
Configuring No Agreement Check Optional
Configuring Protection Functions Optional
In a network containing switches with both GVRP and MSTP enabled, GVRP messages travel along
the CIST. If you want to advertise a VLAN through GVRP, be sure to map the VLAN to the CIST (MSTI
0) when configuring the VLAN-to-MSTI mapping table. For detailed information of GVRP, refer to GVRP
in H3C WX6103 Access Controller Switch Interface Board Configuration Guide.
Configuring the Root Bridge
Configuring an MST Region
Configuration procedure
Follow these steps to configure an MST region:
To do... Use the command... Remarks
Enter system view system-view —
Enter MST region view stp region-configuration —
Configure the MST region
name
region-name name
Optional
The MST region name is the
MAC address by default.
instance instance-id vlan vlan-list
Configure the
VLAN-to-instance mapping
table
vlan-mapping modulo modulo
Optional
Use either command.
All VLANs in an MST region are
mapped to MST instance 0 by
default.
Configure the MSTP revision
level of the MST region
revision-level level
Optional
0 by default
Activate MST region
configuration manually
active region-configuration Required
Display all the configuration
information of the MST region
check region-configuration Optional
Display the currently effective
MST region configuration
information
display stp region-configuration
The display command can be
executed in any view.