H3C Technologies H3C WX6000 Series Access Controllers - Manual (Page 434)

44-7
Line Rate Configuration
Line Rate Configuration Procedure
Follow these steps to configure line rate:
To do… Use the command… Remarks
Enter system view system-view —
Enter port
view
interface interface-type interface-number
Enter
interface
view or port
group view
Enter port
group view port-group { manual port-group-name |
aggregation agg-id }
Enter either view.
For Ethernet interface view, the
following configuration takes effect
only on the current interface. For
entering port group view, the
following configuration takes effect
on all the ports.
Configure line rate
qos lr outbound cir
committed-information-rate
[ cbs
committed-burst-size ]
Required
Line Rate Configuration Examples
Limit the outbound rate of GigabitEthernet 0/0/1 to 640 kbps.
# Enter system view
system-view
# Enter interface view
[Sysname] interface GigabitEthernet 0/0/1
# Configure line rate parameter and limit the outbound rate to 640 kbps
[Sysname-GigabitEthernet0/0/1] qos lr outbound cir 640
Displaying and Maintaining Line Rate
To do… Use the command… Remarks
Display the line rate configuration
of an interface display qos lr interface
[ interface-type interface-number ]
Available in any view