H3C Technologies H3C WX6000 Series Access Controllers - Manual (Page 84)

9-7
Configuration procedure
1) Configure AC
# Enable GVRP globally.
system-view
[AC] gvrp
# Configure port GigabitEthernet 0/0/1 as a Trunk port, allowing all VLANs to pass.
[AC] interface GigabitEthernet 0/0/1
[AC-GigabitEthernet0/0/1] port link-type trunk
[AC-GigabitEthernet0/0/1] port trunk permit vlan all
# Enable GVRP on GigabitEthernet 0/0/1, the Trunk port.
[AC-GigabitEthernet0/0/1] gvrp
[AC-GigabitEthernet0/0/1] quit
# Create VLAN 2 (a static VLAN).
[AC] vlan 2
2) Configure Device
# Enable GVRP globally.
system-view
[Device] gvrp
# Configure port GigabitEthernet 0/0/1 as a Trunk port, allowing all VLANs to pass.
[Device] interface GigabitEthernet 0/0/1
[Device-GigabitEthernet0/0/1] port link-type trunk
[Device-GigabitEthernet0/0/1] port trunk permit vlan all
# Enable GVRP on GigabitEthernet 0/0/1, the Trunk port.
[Device-GigabitEthernet0/0/1] gvrp
[Device-GigabitEthernet0/0/1] quit
# Create VLAN 3 (a static VLAN).
[Device] vlan 3
3) Verify the configuration
# Display dynamic VLAN information on AC.
[AC] display vlan dynamic
Now, the following dynamic VLAN exist(s):
3
# Display dynamic VLAN information on Device.
[Device] display vlan dynamic
Now, the following dynamic VLAN exist(s):
2
Device in this configuration example refers to a device that supports VLAN in a generic sense.