H3C Technologies H3C WX6000 Series Access Controllers - Manual (Page 524)

56-4
Currently, the storage device on an H3C WX6103 access controller switch interface board is the Flash
only, which is named flash:.
Memory space management
You can use the fixdisk command to restore the space of a storage device or the format command to
format a specified storage device as shown in the following table:
To do… Use the command… Remarks
Restore the space of a storage
device
fixdisk device
Optional
Available in user view
Format a storage device format device
Optional
Available in user view
You may use the two commands when some space of a storage device becomes inaccessible due to
abnormal operations for example.
When you format a storage device, all the files stored on it are erased and cannot be restored. In
particular, if there is a startup configuration file on the storage device, formatting the storage device
results in loss of the startup configuration file.
File System Prompt Mode Setting
The file system provides the following two prompt modes:
z alert : where the system warns you about operations that may bring undesirable consequence such
as file corruption or data loss.
z quiet : where the system does not do that in any cases.
To prevent undesirable consequence resulted from misoperations, the alert mode is preferred.
To do… Use the command… Remarks
Enter system view system-view —
Set the operation prompt mode of
the file system
file prompt { alert | quiet }
Optional
The default is alert.
File System Operations Example
# Display the files and the subdirectory under the current directory.
dir