Controlling telnet users by source mac addresses – H3C Technologies H3C WX6000 Series Access Controllers User Manual
Page 52
6-2
To do…
Use the command…
Remarks
Quit to system view
quit
—
Enter user interface view
user-interface
[ type ] first-number
[ last-number ]
—
Apply the ACL to control
Telnet users by source IP
addresses
acl
[ ipv6 ] acl-number { inbound |
outbound
}
Required
The inbound keyword filters the
users trying to Telnet to the current
access controller.
The outbound keyword filters the
users trying to Telnet to other
access controllers from the current
access controller.
Controlling Telnet Users by Source and Destination IP Addresses
Controlling Telnet users by source and destination IP addresses is achieved by applying advanced
ACLs, which are numbered from 3000 to 3999. Refer to ACL in H3C WX6103 Access Controller Switch
Interface Board Configuration Guide
for information about defining an ACL.
To do…
Use the command…
Remarks
Enter system view
system-view
—
Create an advanced ACL or enter
advanced ACL view
acl
[ ipv6 ] number acl-number
[ name acl-name ] [ match-order
{ config | auto } ]
As for the acl number command,
the config keyword is specified by
default.
Define rules for the ACL
rule
[ rule-id ] { permit | deny }
rule-string
Required
You can define rules as needed to
filter by specific source and
destination IP addresses.
Quit to system view
quit
—
Enter user interface view
user-interface
[ type ] first-number
[ last-number ]
—
Apply the ACL to control Telnet
users by specified source and
destination IP addresses
acl
[ ipv6 ] acl-number { inbound |
outbound
}
Required
The inbound keyword filters the
users trying to Telnet to the current
access controller.
The outbound keyword filters the
users trying to Telnet to other
access controllers from the current
access controller.
Controlling Telnet Users by Source MAC Addresses
Controlling Telnet users by source MAC addresses is achieved by applying Layer 2 ACLs, which are
numbered from 4000 to 4999. Refer to ACL in H3C WX6103 Access Controller Switch Interface Board
Configuration Guide
for information about defining an ACL.