H3C Technologies H3C WX6000 Series Access Controllers User Manual
Page 233
24-15
[AC-rip-1] network 172.17.0.0
[AC-rip-1] quit
# Configure Switch.
[Switch] rip
[Switch-rip-1] network 192.168.1.0
[Switch-rip-1] network 10.0.0.0
[Switch-rip-1] quit
# Display the RIP routing table of AC.
[AC] display rip 1 route
Route Flags: R - RIP, T - TRIP
P - Permanent, A - Aging, S - Suppressed, G - Garbage-collect
-------------------------------------------------------------------------
Peer 192.168.1.2 on Vlan-interface100
Destination/Mask Nexthop Cost Tag Flags Sec
10.0.0.0/8 192.168.1.2 1 0 RA 11
From the routing table, you can find RIPv1 uses natural mask.
3) Configure RIP version
# Configure RIPv2 on AC.
[AC] rip
[AC-rip-1] version 2
[AC-rip-1] undo summary
# Configure RIPv2 on Switch.
[Switch] rip
[Switch-rip-1] version 2
[Switch-rip-1] undo summary
# Display the RIP routing table on AC.
[AC] display rip 1 route
Route Flags: R - RIP, T - TRIP
P - Permanent, A - Aging, S - Suppressed, G - Garbage-collect
--------------------------------------------------------------------------
Peer 192.168.1.2 on Vlan-interface100
Destination/Mask Nexthop Cost Tag Flags Sec
10.2.1.0/24 192.168.1.2 1 0 RA 16
10.1.1.0/24 192.168.1.2 1 0 RA 16
From the routing table, you can see RIPv2 uses classless subnet masks.
Since RIPv1 routing information has a long aging time, it will still exist until aged out after RIPv2 is
configured.