H3C Technologies H3C WX6000 Series Access Controllers - Manual (Page 356)

31-9
Displaying and Maintaining LLDP
To do… Use the command… Remarks
Display the global LLDP
information or the information
contained in the LLDP TLVs to be
sent through a port
display lldp local-information [ global |
interface interface-type interface-number ]
Available in any view
Display the information contained
in the LLDP TLVs received through
a port display lldp neighbor-information
[ interface interface-type interface-number ]
[ brief ]
Available in any view
Display LLDP statistics
display lldp statistics [ global | interface
interface-type interface-number ]
Available in any view
Display LLDP status of a port
display lldp status [ interface
interface-type interface-number ]
Available in any view
Display the types of the LLDP
TLVs that are currently sent display lldp tlv-config [ interface
interface-type interface-number ]
Available in any view
LLDP Configuration Example
LLDP Configuration Example
Network requirements
z
The NMS and AC are located in the same Ethernet. An MED device and Switch are connected to
GigabitEthernet 0/0/1 and GigabitEthernet 0/0/2 of AC.
z
Enable LLDP on the ports of AC and Switch to monitor the link between AC and Switch and the link
between AC and the MED device on the NMS.
Network diagram
Figure 31-1 Network diagram for LLDP configuration
Configuration procedure
1) Configure AC.
# Enter system view.