H3C Technologies H3C WX6000 Series Access Controllers - Manual (Page 346)

30-3
Network diagram
Figure 30-2 Network diagram for multicast VLAN configuration
Configuration procedure
1) Configure an IP address for each interconnecting interface
Configure an IP address and subnet mask for each interface as per Figure 30-2 . The detailed
configuration steps are omitted here.
2) Configure Router
# Enable IP multicast routing, enable PIM-DM on each interface and enable IGMP on GigabitEthernet
0/0/1.
system-view
[Router] multicast routing-enable
[Router] interface GigabitEthernet 0/0/1
[Router-GigabitEthernet0/0/1] pim dm
[Router-GigabitEthernet0/0/1] igmp enable
[Router-GigabitEthernet0/0/1] quit
[Router] interface GigabitEthernet 0/0/2
[Router-GigabitEthernet0/0/2] pim dm
[Router-GigabitEthernet0/0/2] quit
3) Configure AC
# Enable IGMP Snooping globally.
system-view
[AC] igmp-snooping
[AC-igmp-snooping] quit
# Create VLAN 11 and assign GigabitEthernet 0/0/2 to this VLAN.
[AC] vlan 11
[AC-vlan11] port GigabitEthernet 0/0/2
[AC-vlan11] quit
The configuration for VLAN 12 and VLAN 13 is similar to the configuration for VLAN 11.