H3C Technologies H3C WX6000 Series Access Controllers - Manual (Page 588)

63-9
To do… Use the command… Remarks
Enter system view system-view —
Enter NQA test group view
nqa entry admin-name
operation-tag
—
Configure the test type as HTTP
and enter test type view
type http Required
Configure the destination address
for a test operation
destination ip ip-address
Required
By default, no destination IP
address is configured for a test
operation.
The destination IP address for a
test operation is the IP address of
the HTTP server.
Configure the source IP address of
a probe request
source ip ip-address
Optional
By default, no source IP address is
specified.
The source IP address must be
that of an interface on the device
and the interface must be up.
Otherwise, the test will fail.
Configure the operation type operation { get | post }
Optional
By default, the operation type for
the HTTP is get, that is, obtaining
data from the HTTP server.
Configure the website that an
HTTP test visits
url url Required
Configure the HTTP version used
in the HTTP test
http-version v1.0
Optional
By default, HTTP 1.0 is used in an
HTTP test.
Configure common optional
parameters
Refer to Configuring Optional
Parameters Common to an NQA
Test Group Optional
The TCP port number for the HTTP server must be 80 in an HTTP test. Otherwise, the test will fail.
Configuring the UDP-jitter Test
You are not recommended to perform an NQA UDP-jitter test on ports from 1 to 1023 (known ports).
Otherwise, the NQA test will fail or the corresponding services of this port will be unavailable.