H3C Technologies H3C WX6000 Series Access Controllers - Manual (Page 583)

63-4
specified for a listening service on the server must be consistent with those on the client and must be
different from those of an existing listening service.
NQA Test Operation
After you create a test group and enter the test group view, you can configure related test parameters.
Test parameters vary with the test type. For details, see the configuration procedure below.
To perform an NQA test successfully, make the following configurations on the NQA client:
1) Enable the NQA client;
2) Create a test group and configure test parameters according to the test type;
3) Perform the NQA test through the nqa schedule command.
4) View test results using the display or debug commands.
For TCP, UDP-jitter or UDP-echo tests, you need to configure the NQA server on the peer device.
NQA Configuration Task List
Complete these tasks to configure NQA.
Task Remarks
Configuring the NQA Server
Required for TCP, UDP-echo and
UDP-jitter tests
Enabling the NQA Client Optional
Creating an NQA Test Group Required
Configuring the ICMP-echo Test
Configuring the DHCP Test
Configuring the FTP Test
Configuring the HTTP Test
Configuring the UDP-jitter Test
Configuring the SNMP Test
Configuring the TCP Test
Configuring the UDP-echo Test
Configuring an NQA Test
Group
Configuring the DLSw Test
Use any of the approaches.
Configuring the Collaboration Function Optional
Configuring Trap Delivery Optional
Configuring Optional Parameters Common to an NQA Test Group Optional
Scheduling an NQA Test Group Required
Configuring the NQA Server
Before performing TCP, UDP-echo or UDP-jitter tests, you need to configure the NQA server on the
peer device. The NQA server makes a response to the request originated by the NQA client by listening
to the specified destination address and port number.
Follow these steps to configure the NQA server: