H3C Technologies H3C WX6000 Series Access Controllers - Manual (Page 228)

24-10
To do… Use the command… Remarks
Configure the filtering of
incoming routes
filter-policy { acl-number | gateway ip-prefix-name
| ip-prefix ip-prefix-name [ gateway
ip-prefix-name
] } import [ interface-type
interface-number ]
Required
Not configured by default
Configure the filtering of
outgoing routes
filter-policy { acl-number | ip-prefix
ip-prefix-name } export [ protocol [ process-id ] |
interface-type interface-number ]
Required
Not configured by default
z
Using the filter-policy import command filters incoming routes. Routes not passing the filtering
will be neither installed into the routing table nor advertised to neighbors.
z
Using the filter-policy export command filters outgoing routes, including routes redistributed with
the import-route command.
Configuring a Priority for RIP
Multiple IGP protocols may run in a router. If you want RIP routes to have a higher priority than those
learned by other routing protocols, you can assign RIP a smaller priority value to influence optimal route
selection.
Follow these steps to configure a priority for RIP:
To do… Use the command… Remarks
Enter system view system-view ––
Enter RIP view rip [ process-id ] ––
Configure a priority for RIP preference value
Optional
100 by default
Configuring RIP Route Redistribution
Follow these steps to configure RIP route redistribution:
To do… Use the command… Remarks
Enter system view system-view ––
Enter RIP view rip [ process-id ] ––
Configure a default metric for
redistributed routes
default-cost value
Optional
The default metric of a
redistributed route is 0 by default.
Redistribute routes from another
protocol import-route protocol [ cost cost |
tag tag ] *
Required
No redistribution is configured by
default.