H3C Technologies H3C WX6000 Series Access Controllers - Manual (Page 132)

17-1
17
Link Aggregation Configuration
When configuring link aggregation, go to these sections for information you are interested in:
z
Configuring Link Aggregation
z
Displaying and Maintaining Link Aggregation
z
Link Aggregation Configuration Example
Configuring Link Aggregation
This section covers these topics:
z
Configuring a Manual Link Aggregation Group
z
Configuring a Static LACP Link Aggregation Group
z
Configuring an Aggregation Group Name
z
Entering Aggregation Port Group View
Configuring a Manual Link Aggregation Group
Follow these steps to create a manual aggregation group and add an Ethernet port to it:
To do… Use the command… Remarks
Enter system view system-view ––
Create a manual aggregation
group
link-aggregation group agg-id mode manual Required
Enter Ethernet port view interface interface-type interface-number ––
Assign the Ethernet port to the
aggregation group
port link-aggregation group agg-id Required
Note that:
z
You can create a manual aggregation group by changing the type of an existing static aggregation
group. When you create a manual aggregation group in this way and the static aggregation group
contains ports, LACP is disabled on the ports after the manual aggregation group is created.
z
An aggregation group cannot contain the following ports: ports configured with static MAC
addresses or black hole MAC addresses, voice VLAN-enabled ports, or 802.1x-enabled ports.
z
After you remove a manual aggregation group, all the ports in the group are dismissed from it.
z
For a manual aggregation group containing only one port, the only way to remove the port from it is
to remove the aggregation group.
z
To make an aggregation group to function properly, make sure the selected states of the ports on
the both sides of the same link are the same.
Configuring a Static LACP Link Aggregation Group
Follow these steps to configure a static aggregation group: