H3C Technologies H3C WX6000 Series Access Controllers - Manual (Page 472)

52-4
To do… Use the command… Remarks
Configure the maximum size of an
SNMP packet that can be received
or sent by an SNMP agent
snmp-agent packet max-size
byte -count
Optional
1,500 bytes by default
Configure the engine ID for a local
SNMP agent snmp-agent local-engineid
engineid
Optional
Company ID and device ID by
default
Create or update the MIB view
content for an SNMP agent
snmp-agent mib-view { excluded
| included } view-name oid-tree
[ mask mask-value ]
Optional
MIB view name is ViewDefault and
OID is 1 by default.
Follow these steps to configure SNMPv1 and SNMPv2c:
To do… Use the command… Remarks
Enter system view system-view —
Enable SNMP Agent snmp-agent
Required
Disabled by default
You can enable SNMP Agent
through this command or any
commands that begin with
snmp-agent
.
Configure SNMP Agent system
information
snmp-agent sys-info { contact
sys-contact | location sys-location
| version { { v1 | v2c | v3 }* | all } }
Required
The defaults are as follows:
Hangzhou H3C Tech. Co., Ltd. for
contact,
Hangzhou, China for location and
SNMP v3 for the version.
Configur
e directly
Configur
e a
communi
ty name snmp-agent community { read |
write } community-name [ acl
acl-number | mib-view
view-name ]*
Configur
e an
SNMP
group
snmp-agent group { v1 | v2c }
group-name [ read-view
read-view ] [ write-view
write-view ] [ notify-view
notify-view ] [ acl acl-number ]
Configur
e SNMP
NMS
access
right
Configur
e
indirectly
Add a
new user
to an
SNMP
group
snmp-agent usm-user { v1 | v2c }
user-name group-name [ acl
acl-number ]
Use either approach.
Both commands can be used to
configure SNMP NMS access
rights. The second command was
introduced to be compatible with
SNMPv3.
The community name configured
on NMS should be consistent with
the username configured on the
Agent.
Configure the maximum size of an
SNMP packet that can be received
or sent by an SNMP agent
snmp-agent packet max-size
byte -count
Optional
15,00 bytes by default
Configure the engine ID for a local
SNMP agent snmp-agent local-engineid
engineid
Optional
Company ID and device ID by
default
Create or update MIB view content
for an SNMP agent
snmp-agent mib-view
{ excluded | included }
view
-name oid-tree [ mask
mask-value ]
Optional
ViewDefault by default