H3C Technologies H3C WX6000 Series Access Controllers - Manual (Page 114)

14-1
14
Port Correlation Configuration
The term switch in this document refers to a switch in a generic sense or an access controller
configured with the switching function unless otherwise specified.
When configuring Ethernet ports, go to these sections for information you are interested in:
z
Ethernet Port Configuration
z
Maintaining and Displaying an Ethernet Port
Ethernet Port Configuration
Complete the following tasks to configure an Ethernet port:
Task Remarks
Performing Basic Ethernet Port Configuration Optional
Combo Port Configuration Optional
Enabling Flow Control on an Ethernet Port Optional
Enabling Loopback Test on an Ethernet Port Optional
Configuring a Port Group Optional
Configuring the Broadcast/Multicast/Unknown Unicast Storm Suppression Ratio for
an Ethernet Port
Optional
Enabling Forwarding of Jumbo Frames Optional
Enabling Loopback Detection on an Ethernet Port Optional
Configuring the Cable Type for an Ethernet Port Optional
Testing the Cable on an Ethernet Port Optional
Configuring the Storm Constrain Function on an Ethernet Port Optional
Performing Basic Ethernet Port Configuration
Three types of duplex modes are available to Ethernet ports:
z
Full-duplex mode (full). Ports operating in this mode can send and receive packets simultaneously.
z
Half-duplex mode (half). Ports operating in this mode can either send or receive packets at a given
time.
z
Auto-negotiation mode (auto). Ports operating in this mode determine their duplex mode through
auto-negotiation.