H3C Technologies H3C WX6000 Series Access Controllers - Manual (Page 633)

65-5
To do… Use the command… Remarks
Display a list of all commands or
the help information of an SFTP
client command
help [ all | command-name ] Required
Terminating the Connection to the Remote SFTP Server
Follow these steps to terminate the connection to the remote SFTP server:
To do… Use the command… Remarks
Establish a connection to
the remote SFTP server
and enter SFTP client view
sftp [ ipv6 ] server [ port-number ]
[ identity-key { dsa | rsa } |
prefer-ctos-cipher
{ aes128 | des } |
prefer-ctos-hmac { md5 | md5-96 | sha1 |
sha1-96 } | prefer-kex { dh-group-exchange
| dh-group1 | dh-group14 } |
prefer-stoc-cipher
{ aes128 | des } |
prefer-stoc-hmac { md5 | md5-96 | sha1 |
sha1-96 } ] *
Required
Execute the command in user
view.
bye
exit
Terminate the connection to
the remote SFTP server
and return to user view
quit
Required.
Use any of the commands.
These three commands
function in the same way.
SFTP Configuration Example
Network requirements
As shown in Figure 65-1 , an SSH connection is established between AC and Switch. AC, an SFTP
client, uses the username client001 and password aabbcc to login to Switch for file management and
file transfer.
Network diagram
Figure 65-1 Network diagram for SFTP configuration
SFTP server SFTP client
Switch AC
Vlan-int1
192.168.0.2/24
Vlan-int1
192.168.0.1/24
Configuration procedure
1) Configure the SFTP server (Switch)
# Generate RSA and DSA key pairs and enable the SSH server.
system-view
[Switch] public-key local create rsa
[Switch] public-key local create dsa
[Switch] ssh server enable