H3C Technologies H3C WX6000 Series Access Controllers - Manual (Page 576)

62-1
62
Device Management
When configuring device management, go to these sections for information you are interested in:
z
Device Management Overview
z
Configuring Device Management
z
Displaying and Maintaining Device Management Configuration
File names in this document comply with the following rules:
z
Path + file name (namely, a full file name): File on a specified path. A full file name consists of 1 to
135 characters.
z
“File name” (namely, only a file name without a path): File on the current working path. The file
name without a path consists of 1 to 91 characters.
Device Management Overview
Through the device management function, you can view the current working state of a device, configure
running parameters, and perform daily device maintenance and management.
Currently, the following device management functions are available:
z
Rebooting a Device
z
Specifying a Boot ROM File for the Next Device Boot
z
Upgrading Boot ROM
z
Clearing the 16-bit Interface Indexes Not Used in the Current System
Configuring Device Management
Rebooting a Device
When a fault occurs to a running device, you can remove the fault by rebooting the device, depending
on the actual situation. You can set a time at which the device can automatically reboot. You can also
set a delay so that the device can automatically reboot in the delay.
Follow these steps to reboot a device:
To do… Use the command… Remarks
Reboot a device reboot
Optional
Available in user view.