H3C Technologies H3C WX6000 Series Access Controllers - Manual (Page 605)

63-26
Failures due to no connection: 0
Failures due to sequence error: 0
Failures due to internal error: 0
Failures due to other errors: 0
DLSw Test Configuration Example
Network requirements
Use the NQA DLSw function to test the response time of the DLSw device.
Network diagram
Figure 63-11 Network diagram for the DLSw test
Configuration procedure
# Create a DLSw test group and configure related test parameters.
system-view
[AC] nqa entry admin test
[AC-nqa-admin-test] type dlsw
[AC-nqa-admin-test-dlsw] destination ip 10.2.2.2
[AC-nqa-admin-test-dlsw] quit
# Enable the DLSw test.
[AC] nqa schedule admin test start-time now lifetime forever
# Display results of one DLSw test.
[AC] display nqa result admin test
NQA entry(admin admin, tag test) test results:
Destination IP address: 10.2.2.2
Send operation times: 1 Receive response times: 1
Min/Max/Average round trip time: 19/19/19
Square-Sum of round trip time: 361
Last succeeded probe time: 2007-03-27 15:32:48.5
Extend results:
Packet lost in test: 0%
Failures due to timeout: 0
Failures due to disconnect: 0
Failures due to no connection: 0
Failures due to sequence error: 0
Failures due to internal error: 0
Failures due to other errors: 0