H3C Technologies H3C WX6000 Series Access Controllers - Manual (Page 449)

47-3
To do… Use the command… Remarks
Enter system view system-view —
Enter priority mapping table view
qos map-table { dot1p-dp |
dot1p-lp | dscp-dot1p | dscp-dp |
dscp-dscp }
Required
To configure a priority mapping
table, you need to enter the
corresponding priority mapping
table view.
Configure priority mapping
parameters import import-value-list export
export-value
Required
The newly configured mapping
entries overwrite the
corresponding previous entries.
Configuration Examples
Network requirements
Modify the dot1p-lp mapping table as those listed in Table 47-3 .
Table 47-3 The specified dot1p-lp mapping
802.1p precedence Local precedence
0 0
1 0
2 1
3 1
4 2
5 2
6 3
7 3
Configuration procedure
# Enter system view.
system-view
# Enter dot1p-lp priority mapping table view.
[Sysname] qos map-table dot1p-lp
# Modify dot1p-lp priority mapping parameters.
[Sysname-maptbl-dot1p-lp] import 0 1 export 0
[Sysname-maptbl-dot1p-lp] import 2 3 export 1
[Sysname-maptbl-dot1p-lp] import 4 5 export 2
[Sysname-maptbl-dot1p-lp] import 6 7 export 3
Configuring the Port Priority
By default, if a port receives packets without 802.1q tags, the switch takes the priority of the receiving
port as the 802.1p precedence of the received packets, searches the dot1p-lp/dp mapping table for the
corresponding local precedence and drop precedence according to the 802.1p precedence of the