H3C Technologies H3C WX6000 Series Access Controllers - Manual (Page 603)

63-24
Extend results:
Packet lost in test: 0%
Failures due to timeout: 0
Failures due to disconnect: 0
Failures due to no connection: 0
Failures due to sequence error: 0
Failures due to internal error: 0
Failures due to other errors: 0
TCP Test Configuration Example
Network requirements
Use the NQA TCP function to test the time for establishing a TCP connection between AC and Switch.
The port number used is 9000.
Network diagram
Figure 63-9 Network diagram for the TCP test
Configuration procedure
1) Configure Switch.
# Enable the NQA server and configure the listening IP address as 10.2.2.2 and port number as 9000.
system-view
[Switch] nqa server enable
[Switch] nqa server tcp-connect 10.2.2.2 9000
2) Configure AC.
# Create a TCP test group and configure related test parameters.
system-view
[AC] nqa entry admin test
[AC-nqa-admin-test] type tcp
[AC-nqa-admin-test-tcp] destination ip 10.2.2.2
[AC-nqa-admin-test-tcp] destination port 9000
[AC-nqa-admin-test-tcp] quit
# Enable the TCP test.
[AC] nqa schedule admin test start-time now lifetime forever
# Display results of one TCP test.
[AC] display nqa result admin test
NQA entry(admin admin, tag test) test results:
Destination IP address: 10.2.2.2
Send operation times: 1 Receive response times: 1
Min/Max/Average round trip time: 13/13/13
Square-Sum of round trip time: 169
Last succeeded probe time: 2000-04-27 14:03:20.1
Extend results:
Packet lost in test: 0%