H3C Technologies H3C WX6000 Series Access Controllers - Manual (Page 593)

63-14
To do… Use the command… Remarks
Configure the destination address
for a test operation
destination ip ip-address
Required
By default, no destination IP
address is configured for a test
operation.
The destination address must be
the IP address of the listening
service configured on the NQA
server.
Configure the destination port destination port port-number
Required
By default, no destination port
number is configured for a test
operation.
The destination port number must
be the port number of the listening
service configured on the NQA
server.
Configure the size of probe
packets sent
data-size size
Optional
100 bytes by default.
Configure the string of fill
characters of a probe packet sent
data-fill string
Optional
The string of fill characters of an
ICMP probe packet is the string
corresponding with the ASCII code
00 to 09 by default.
Specify a source port number for a
probe request in a test operation
source port port-number
Optional
By default, no source port number
is specified.
Configure the source IP address of
a probe request in a test operation
source ip ip-address
Optional
By default, no source IP address is
specified.
The source IP address must be
that of an interface on the device
and the interface must be up.
Otherwise, the test will fail.
Configure common optional
parameters
Refer to Configuring Optional
Parameters Common to an NQA
Test Group Optional
Configuring the DLSw Test
The DLSw test is used to test the response time of the DLSw device.
Configuration prerequisites
Enable the DLSw function on the peer device before DLSw test..
Configuring the DLSw test
Follow these steps to configure the DLSw test:
To do… Use the command… Remarks
Enter system view system-view —
Enter NQA test group view
nqa entry admin-name
operation-tag
—